Factors affecting gas cooker valve surface quality

Influence line gas cooker valve artificial surface quality control and improvement of human factors for hydraulic control and improvement of the primary elements of the selection process include technical judge and processing methods, which can be accomplished through the following points:
1, the rational organization of the road cut. Guiding principle of this method is to avoid damage to the gas cooker valve material of the original internal stress balance and avoid the workpiece material in the cutting process due under the effect of copper ball valves fixture by hydraulic road unreasonable seizures in tissue incision significant deformation, resulting cut surface quality. For example: Some parting piece of its holding should be organized at the end, so that the processing of rigid better. As shown below, during a road cut for the fault, b is the correct path to cut.
  2, the correct selection of cutting parameters. About gas cookers is not the same rough and finish, its speed and yarn tension wire to the parameter list for the foundation should be properly adjusted to ensure that the gas cooker valve with higher accuracy and surface quality can be properly raised line wire cut machine tension, although the production line cutting machine manufacturers supply a habit is not the same as cutting conditions associated parameters, but due to a Gas Cooker valve the workpiece material, the demand for precision and the impact of other factors, so we can not completely cut copy books presented open conditions, but these conditions should be the foundation, based on the actual needs to be adjusted accordingly. E.g., a thickness of the workpiece to machining 27mm, the processing conditions can not be found in the appropriate condition table, under such conditions, it is necessary to make adjustments in accordance with the thickness of 20mm ~ 30mm between cutting conditions, the primary method is: Processing the thickness of the cooker valve near to which a standard thickness on the selection process which is to be set thickness.